Need a Data Recovery? - Follow the simple steps below!

Step 1

 

3 Send your Hard Disk to Salvation Data, 105 Upper Lisburn Road, Belfast, BT10 0LG

 

3Send us your Hard Drive. Make sure to include your name and address inside package.

 

 

Step 2

 

We will Recover your Data from your PC or Mac Hard Disk for 249.99+vat within 24-72 Hours not Weeks! We offer the best value service within UK.

Step 3

 

3 You verify the data via email or telephone.

3We will let you decide what method you want the data backed up.

3 We dispatch data to you on a next day service

Our Address: Salvation Data 105 Upper Lisburn Road, Belfast BT10 0LG Email us 24x 7 at sales@salvationdata.co.uk

 

Quantum LM40A011 Data Recovery Details


quantum

Quantum drives fail and the LM40A011 is no exception to this.

Quantum Desktop Hard Drive Quantum Notebook Hard Drive Quantum Scsi Hard Drive Quantum Desktop Hard Drive

My computer is setup with a Raid-1 array. One of the drives dropped off the Raid array. I went into the raid utility to rebuild it. I chose the rebuild button and nothing happened. When I looked at the drives in the case, the sata infomation cable slipped off the drive. I turned off the computer, re-attached the cable and rebooted. The computer sees the drives as it's booting up, but, just goes past the raid utility. It won't enter it. Then when it gets to Windows, it says, "Disk Boot Failure. Please insert a system disk.." ..K Collins, Kent, UK

Quantum hard disks are well-known for their factory firmware problems. Factory Firmware is stored on the disk platters in the so-called System (Service) Area of the hard disk. If one of the disk modules becomes corrupted the whole hard disk micro-operating system can't boot up, the drive cannot initialise correctly and thus stops working. If you attempt to boot up from such a Quantum hard drive or read any data from it you would get "Disk boot failure. Insert system disk and press enter" or "Primary Master Hard Disk Fail" or "No operating system found" or "USB Device malfunctioned" error or "S.M.A.R.T. Capable But Command Failed" or some other BIOS error.

Currently there is no way to fix this type of firmware corruption at home. It is quite a complicated procedure and requires use of specialised expensive equipment and deep knowledge of hard drive design and data recovery technology.

I have 3 Hard drives in my PC. They have been running for me for over 3 years. Last night, I hear some weired noise from my hard disk and I feel the operating system became so slow and sluggish. I then installed HDD Health to check the health and temperature. So I really have no idea what makes my computer slow down. The only thing I can think of is I set the page file on the critical HD. So I changed it back to system disk. After I reboot my pc, it went though CHKDISK and I saw a lot of index error there... after that, I was able to use my pc again, but still so slow. I tried to reboot one more time and this time, I cannot even boot. ..Jane Smith, London, UK

The No1 issue for Quantum hard drives (especially Quantum CX and Quantum LCT series) is damage to components on the PCB board. Quantum Hard Drives are vunerable to overheating and power surges which can lead to a burned out motor or blowing a controller chip on the logic board. If the chips on the PCB burn out you would smell smoke in the air. On next boot your Quantum hard disk will probably not even spin up.

The Quantum drive can spin up and the head starts clicking right from the beginning with a regular clicking sound . More times than not this a sign of bad heads, if this is the case it is very important to perform accurate diagnostics and eliminate a chance of possible firmware corruption or PCB failure that sometimes could also cause clicking.

The last typical Quantum hard drive issue applies also to all other hard drive makes and models, the problem is called bad sectors. After some period of time the platters were the data is located starts to degrade and bad sectors appear.
Whenever the hard drive attempts to read bad sectors it could start freezing, scratching, ticking and sometimes loud clicking. This leads to further damage to the surface and causes more data loss. As soon as you start experiencing such symptoms while reading important files, stop the drive immediately and consider sending it to a data recovery company like ourselves for a free diagnostic. Any further attempts to read the Quantum drive would just add up to the problems and make more data unrecoverable. In our Data Recovery Lab we use expensive imaging tools that are capable of force reading bad sectors from Quantum Hard Disks. This is usually the only way to effectively retrieve data from these Drives.

If you experience any of the symptoms described above with your Quantum LM40A011 please call us on +44 (0) 2890 961976.

If you hear your Quantum LM40A011 hard drive making some other unusual noises please call us on +44 (0) 2890 961976.


 

Recession

Price


with every recovery!